Hide Table of Contents

Adding Components to the Library

You can import many 3D components into SolidWorks, or you can create them. When you have the component you need, add connection and route points to it, and add the part to the Component library.

Most suppliers can supply either 3D models or dimensioned drawings of components. In many cases you can import the 3D models directly into SolidWorks. If not, you may need to model them. Once you have the model, add CPoints or RPoints as needed.

You can also download some components from the web site www.3dcontentcentral.com.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Components to the Library
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26