> Vertical Ordinate Dimensions
Introduction
What's New
Administration
User Interface
SolidWorks Fundamentals
Moving from 2D to 3D
Assemblies
CircuitWorks
Configurations
Design Checker
Design Studies in SolidWorks
Detailing and Drawings
DFMXpress
DriveWorksXpress
FloXpress
Import/Export
Mold Design
Motion Studies
Parts and Features
PhotoView 360
PhotoWorks
Routing
Sheet Metal
Simulation
SimulationXpress
Sketching
Sustainability Products
SolidWorks Utilities
Tolerancing
Toolbox
Weldments
Workgroup PDM
Troubleshooting
Glossary
Hide Table of Contents Show Table of Contents

Vertical Ordinate Dimensions

Creates vertical ordinate dimensions in a drawing or sketch, measured vertically from the entity you select first.

To create vertical ordinate dimensions:

  1. With a drawing or sketch active, click Vertical Ordinate Dimension on the Dimensions/Relations toolbar, or click Tools, Dimensions, Vertical Ordinate.

  2. Click the first item from which all others will be measured, and click again to place the dimension.

  3. Click an item to dimension. Repeat this step until all the remaining items are dimensioned.

    The dimension tool remains in ordinate mode until you select another mode or another tool.

Related Topics

Horizontal Ordinate Dimensions
Ordinate Dimensions



Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Vertical Ordinate Dimensions
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2010 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2010 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.