Hide Table of Contents

Comparing SolidWorks FloXpress to SolidWorks Flow Simulation


SolidWorks FloXpress

SolidWorks Flow Simulation

3D Flow


Flow Trajectories

Assembly Analysis

Part Analysis

Flow Opening Boundary Conditions

Pressure Opening Boundary Conditions

Steady Problems

Internal Problems

2D Flow


Boundary Conditions:

  • Ideal Wall

  • Moving Wall

  • Transferred Boundary


Contact Resistances


External Problems




Fluid Subdomains




Heat Sink Simulations


Heat Transfer


Iso surfaces


Mesh Settings


Mesh Visualization


Particle Studies



  • 3D-Profile

  • Cut

  • Goal

  • Surface

  • XY


Point, Surface, and Volume Parameters


Porous Media






Solid Materials


Thermoelectric Coolers


Transient Problems


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Comparing SolidWorks FloXpress to SolidWorks Flow Simulation
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.