Hide Table of Contents

RECTANGLE

Draws a rectangle.

 

Specify:

1 first corner
2
opposite corner

Options are:

CHAMFER  Specify two numbers, for distances on the two sides
FILLET   Specify one number for fillet radius

The specifications for the CHAMFER and FILLET options remain in effect until you reset them; therefore, you can draw any number of rectangles with the same chamfer or fillet. You can also apply CHAMFER and FILLET separately after the rectangle is drawn.

Each side of the rectangle is a separate entity.

RECTANG is an accepted abbreviation for RECTANGLE.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   RECTANGLE
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.