Hide Table of Contents

'SNAP

Restricts cursor movement to specified intervals.

 

Specify:

1 ON/OFF

2 Snap spacing

3 Aspect (allows Horizontal and Vertical intervals to be different)

4 Rotate (asks for Base Point and Rotation Angle)

The rotation angle can be between -90 and 90 degrees. A positive angle rotates the grid counterclockwise about the base point; a negative angle rotates the grid clockwise.

Changing the snap spacing affects the coordinates only of new points; objects already in the drawing retain their existing coordinates.

Snap spacing is invisible. 'GRID displays a dot grid.

You can toggle SNAP to be ON or OFF by pressing the F9 function key, or by double-clicking SNAP on the status bar.

See also 'OSNAP, 'ORTHO, Function Key Toggles, Transparent Commands.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   'SNAP
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.