> Routing > Pipes and Tubes > Working with Routing Assemblies > Route Properties > Changing Properties for Subsequent Route Segments
Introduction
What's New
Administration
User Interface
SolidWorks Fundamentals
Moving from 2D to 3D
Assemblies
CircuitWorks
Configurations
Design Checker
Design Studies in SolidWorks
Detailing and Drawings
DFMXpress
DriveWorksXpress
FloXpress
Import/Export
Mold Design
Motion Studies
Parts and Features
PhotoView 360
PhotoWorks
Routing
Routing Overview
Routing Options and File Locations
Routing Templates
Routing Best Practices
Toolbars
Connection Points and Route Points
Pipes and Tubes
General Procedure for Pipes and Tubes
Components
Working with Routing Assemblies
Highlight Search Pane
Visualizing the 3D Space
Route Properties
Changing Properties for Subsequent Route Segments
Changing Properties of an Existing Route Segment
Route Properties PropertyManager
Mating in Routing Sub-assemblies
Editing a Routing Sub-assembly
Changing the Diameter of a Route
Split Route
Adding Fittings
Custom Pipe or Tube Configurations
Custom Elbow Fittings
Segment to Segment Penetration
Editing the Structure
Remove Pipe or Tube
Standard Tubes
Exporting Pipe and Tube Data
P&ID File Import
Piping and Instrumentation Pane
Drawings of Routing Assemblies
Electrical Cables
Coverings
Sheet Metal
Simulation
SimulationXpress
Sketching
Sustainability Products
SolidWorks Utilities
Tolerancing
Toolbox
Weldments
Workgroup PDM
Troubleshooting
Glossary
Hide Table of Contents Show Table of Contents

Changing Properties for Subsequent Route Segments

You change the route properties for all subsequent route segments in the Route Properties PropertyManager.

While creating a route, or starting a new route, you can change route properties to apply to all segments created after you insert the next fitting. This does not change the properties of segments created up to that point.

To change the route properties for all subsequent route segments:

  1. Do one of the following:
    • Click Route Properties .
    • Right-click a route feature in the FeatureManager design tree and select Route Properties.
  2. Set options in the Route Properties PropertyManager.
  3. Click .


Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing Properties for Subsequent Route Segments
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2010 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2010 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.