Hide Table of Contents

Stationary Corners for Tables

A table stationary corner controls the direction in which the drawing table expands when adding new columns or rows.

Top Left New columns extend to the right and new rows extend below the anchor point.
Top Right New columns extend to the left and new rows extend below the anchor point.
Bottom Left New columns extend to the right and new rows extend above the anchor point.
Bottom Right New columns extend to the left and new rows extend above the anchor point.
You cannot select the stationary corner when you first create the table. If the table is anchored, the stationary corner is automatically selected on the drawing sheet in the quadrant nearest the table anchor.

For more information, see SolidWorks Help: Bill of Materials PropertyManager or Table PropertyManager. See also SolidWorks Help: Table Anchors.

In this example, the BOM has a top left stationary corner.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Stationary Corners for Tables
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.