Hide Table of Contents

Adding Explode Lines

To add explode lines to an exploded view, use an Explode Line Sketch (a type of 3D sketch).

To insert an explode line sketch:

  1. Click Explode Line Sketch (Assembly toolbar) or Insert, Explode Line Sketch.

The Route Line PropertyManager appears.

  1. Add explode lines using:

All lines appear in phantom font.

  1. Close the sketch.

The sketch appears in the ConfigurationManager under ExplView<n>.

To edit an explode line sketch:

  1. In the ConfigurationManager, click to expand ExplView<n>.

  2. Right-click 3DExplode<n>, and select Edit Sketch.

  3. Edit the sketch as you would for any 3D sketch, or add more explode lines.

  4. Close the sketch.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Explode Lines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.