Adding a Component Pattern
You can create a pattern of components in the assembly in one of the
following ways:
You can create a local linear
or circular
pattern of components.
You can place a pattern of components in an assembly
based on a feature pattern of an existing component. This is called a
derived
component pattern.
You can place a pattern of components in an assembly
based on a feature pattern of assembly features.
To toggle the visibility or suppression state of all of the components
in the pattern, right-click the pattern feature in the FeatureManager
design tree, and select Hide components,
Show components, Suppress,
Unsuppress, or Isolate Components.
You can dissolve a component
pattern to make its components independent. One benefit is that you can
individually move and rotate components that were in the pattern. One
drawback is that you cannot hide and suppress all the components in the
pattern because the pattern feature is gone.