Hide Table of Contents

Component Configurations in an Assembly

If a component (either an individual part or a sub-assembly) has more than one configuration, you can specify which configuration to use for each instance in the assembly. You can specify which configuration to use for several components at a time, if the components have configurations with the same name.

You can also specify certain configuration-specific properties for the component.

To specify component configurations and configuration-specific properties:

  1. Right-click the component and select Component Properties .

To specify configurations for more than one component, hold down Ctrl and select the components, then right-click and select Component Properties . Properties that are common to all the selected components appear in the dialog box.

  1. Set the following options, then click OK.

Configuration specific properties

  • Referenced configuration. Select a configuration from the list. If the selected component is an instance of a component pattern, select one of the following:

    • Use same configuration as pattern seed component. If the selected component is an instance of a component pattern, this is the default setting.

    • Use named configuration. Select to specify a configuration that is different from the seed component, and select a configuration from the list.

  • Change properties in. (Only available in assemblies with more than one configuration.) Sets properties in This configuration, All configurations, or Specify configurations.

  • Suppression state. Controls the suppression state of the component.

  • Solve as. Sets the component as Rigid or Flexible.

  • Exclude from bill of materials. Omits this component from the bill of materials (BOM). Applies to only table-based BOMs, not Excel-based BOMs.

You can also right-click a component and select Configure component to configure the component configuration.

Related Topics

Comparison of Components Suppression States

Component Configurations in a Design Table

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Component Configurations in an Assembly
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26