Cosmetic Thread PropertyManager
Specify the following properties when inserting a cosmetic thread in a part, assembly,
or drawing.
Thread Settings
Circular Edges 
. Select a circular edge in the graphics area.
Standard. Lets you set the dimensioning
standard for the cosmetic thread.
Type. Lets you select the type
of threads.
Size. Lets you select the size
of the cosmetic thread based on the dimensioning standard you selected.
Valid values for the selected edge are listed.
Minor Diameter, Major
Diameter, or Conical Offset
. Sets the diameter for the dimension corresponding to
the entity type with the cosmetic thread.
End Condition. The cosmetic
thread extends from the edge selected above to the end condition:
Blind.
A specified depth. Specify the depth below.
Through.
Completely through the existing geometry.
Up to Next.
To the next entity that intercepts the thread.
Depth 
. Enter
a value when the End Condition
is Blind.
Thread Callout
Type text to appear in the thread callout. (The thread callout appears
in drawing documents only.) If you selected a Standard,
the thread callout is driven by the standard and cannot be edited.
Thread callouts are not used in certain dimensioning
standards. If a cosmetic thread callout is defined in the part or assembly
but is not displayed in the drawing, you can display the callout in the
drawing by selecting Insert Callout
from the shortcut menu.
Layer 
In drawings with named layers, select a layer.