Hide Table of Contents

Selection Filter

Selection Filters help select specific types of items in the graphics area or drawing sheet. For example, choose the filter for faces so only faces can be selected.

To toggle the display of the Selection Filter toolbar, click Toggle Selection Filter Toolbar (Standard toolbar), or press F5.

  • The following buttons on the Selection Filter toolbar allow you to specify the behavior of the Selection Filter:

  Toggle Selection Filters. Turns selected filters on or off. You can also press F6.

  Clear All Filters. Clears all selected filters.

  Select All Filters. Selects all filters.

Invert Selection. All other items similar to the selected items (faces, edges, vertices, for example) are selected and the original selections are canceled.

  • The other buttons on the Selection Filter toolbar are filters. Select the filters to match the items you want to select in the graphics area.

  • Keyboard shortcuts are available for some filters:

Edges

E

Faces

X

Vertices

V

When a Selection Filter is active, the pointer changes to , then, when the pointer is near a filtered item, the pointer for that item is displayed; for example, a face .

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Selection Filter
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59