Hide Table of Contents

Check Entity

The Check Entity dialog box enables you to check model geometry and identify undesirable geometry.

To check a model for correct geometry:

  1. With a part document active, click Check (Tools toolbar) or Tools, Check.

  2. In the dialog box, under Check, select the level of checking and the entity type that you want to verify:

  • Stringent solid/surface check. When cleared (default), performs a standard geometry check, which reuses the results of previous geometry checks to improve performance.

When selected, all geometry checks are re-performed, which results in slower performance.

  • All. Checks the entire model. Specify Solids, Surfaces, or both.

  • Selected items. Checks faces or edges that you select in the graphics area.

  • Features. Checks all the features in the model.

  1. Under Check for, select the types of problems you want to check for and the types of values you want to determine:

  • Invalid face(s).

  • Invalid edge(s).

  • Short edge(s). Specify a minimum edge length. The software reports any edges that are less than the specified length.

    • Minimum radius of curvature.

    • Maximum edge gap.

    • Maximum vertex gap.

  1. Click Check.

After checking:

  • The number of errors appear under Found.

  • Items such as errors, open surfaces, and requested values appear under Result list.

  • A description of the results appears in the message area.

Select an item in Result list to highlight it in the graphics area and to display additional information in the message area.

  1. Click Close.

Related Topics

Checking Model Geometry
Model Geometry Overview



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Check Entity
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.