Hide Table of Contents

Editing Options with Two Point Splines

To adjust the raised degree in two point splines:

  1. Create a two point spline.

  2. In Edit Sketch mode, click Add Curvature Control (Spline Tools toolbar) or Tools, Spline Tools, Add Curvature Control.

  1. Right-click the spline and select Show Curvature to preview the effects of the curvature option.

  2. In the Curvature Scale PropertyManager, click .

  3. In the Spline PropertyManager, under Options, select:

    1. Raised Degree to apply curvature.

    2. Standard to clear curvature.

Raised Degree


This option is only available with two point splines that include curvature handles.

  1. Click .

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Editing Options with Two Point Splines
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.