Material Properties Options
Lets you set crosshatch options and material density for the active
part. These options are not available for drawing or assembly documents.
The crosshatch pattern that you select for the part displays in section
views of the part in drawings.
If you have applied
a material to the part, you must remove the material
before you can set properties here.
To set material properties options:
In a part document, click Options
or Tools, Options.
On the Document
Properties tab, click Material
Properties.
-
Type the material density in the Density
box.
You can type the density value with any
units. For example, if the units of the part are grams and millimeters,
you can use a density value of pounds and inches. The software converts
the value to the document’s units when you click OK.
Under Area Hatch/Fill,
select from the following:
If you select Hatch,
do the following:
Select a crosshatch pattern from the Pattern list.
If necessary, set the Scale
and Angle of the crosshatch pattern.
A preview of the pattern is displayed in the preview box when you
click the Pattern list again .
-
Click OK.
You can also change the Density
from the Mass/Section Property
Options dialog box. Click Tools,
Mass Properties, Options, to access this dialog box.