> Detailing and Drawings > Annotations > Inserting Reference Geometry into Drawings
Hide Table of Contents Show Table of Contents

Inserting Reference Geometry into Drawings

Reference geometry in a model is hidden by default in when you create drawing views. However, if  you insert reference geometry with Insert Model Items, entities of the selected types are shown.

When you insert reference geometry into drawings, axes, and points are shown in gray. Surfaces are shown as visible lines (black).

To toggle the display status of an individual reference geometry entity, right-click the entity in the FeatureManager design tree, and select Hide or Show.



Related SolidWorks Forum Content

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting Reference Geometry into Drawings
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2010 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.