Hide Table of Contents

Sketch Fillet Tool

The Sketch Fillet Tool contains numerous enhancements, including a preview mode, entity selection before and after starting the tool, and an enhanced PropertyManager.


  • The fillet preview shows virtual intersections between entities, extending the entities in the preview if necessary to show fillets that are possible for the selected entities.
  • You can specify multiple fillets in a single Sketch Fillet operation. Fillets are not created until you click OK in the PropertyManager.
  • While previewing fillets, you can drag fillets to adjust the radius.
  • You can set the fillet radius in the PropertyManager before or after selecting the entities.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Fillet Tool
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.