Hide Table of Contents

Adding Components and Assembly Fittings to Routes

You can:
  • Make fitting to fitting connections:
    • Drag flanges onto elbows, valves, and other fittings.
    • Drag elbows onto flanges, valves, and other fittings.
  • Split a run of pipe by dragging a fitting or a pair of flanges into the pipe.
  • Create branch lines in a pipe by dragging a tee into the pipe.
  • Drag entire assemblies with appropriate references into a pipe. For example, you can drag an assembly consisting of a valve with four flanges into a pipe.
  • Drag a flange, a gasket, and another flange into a route to insert a gasket between flanges.

Parent topic: Routing


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Components and Assembly Fittings to Routes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48