Hide Table of Contents

Preparing to Split the Part

Create the sketch to use to split the part.

To create the sketch:

  1. Open install_dir\samples\whatsnew\Sheetmetal\casing_base_part.sldprt.



  2. Click Sketch (Sketch toolbar).
  3. Select the front plane.

  4. Click Line > Line (Sketch toolbar).
  5. In the Insert Line PropertyManager, for Orientation, select Vertical.
  6. Sketch a vertical line through the midpoints of the face.

    Extend it beyond the model face.



  7. Exit the sketch.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Preparing to Split the Part
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.