Hide Table of Contents

Maximum Shear Stress Criterion

The maximum shear stress criterion, also known as Tresca yield criterion, is based on the Maximum Shear stress theory.

This theory predicts failure of a material to occur when the absolute maximum shear stress (tmax) reaches the stress that causes the material to yield in a simple tension test. The Maximum shear stress criterion is used for ductile materials.

tmaxslimit/ 2

tmax is the greatest of t12, t23and t13

Where:

t12 = (s1 - s2)/2; t23 = (s2- s3)/2; t13 = (s1- s3)/2

Hence:

Factor of safety (FOS) =  slimit /(2*tmax)

Comparing the von Mises and Tresca Stress Criteria

The maximum shear stress criterion is more conservative than the von Mises stress criterion since the hexagon representing the shear stress criterion is enclosed within the ellipse representing the von Mises stress criterion.

For a condition of pure shear, von Mises stress criterion predicts failure at (0.577*yield strength) whereas the shear stress criterion predicts failure at 0.5 yield strength. Actual torsion tests used to develop pure shear have shown that the von Mises stress criterion gives more accurate results than the maximum shear stress theory.

Related Topics

Performing factor of safety check



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Maximum Shear Stress Criterion
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.