Introduction
What's New
Administration
User Interface
SolidWorks Fundamentals
Moving from 2D to 3D
Assemblies
CircuitWorks
Configurations
Design Checker
Design Studies in SolidWorks
Detailing and Drawings
DFMXpress
DriveWorksXpress
FloXpress
Import/Export
Mold Design
Motion Studies
Parts and Features
PhotoView 360
PhotoWorks
Routing
Routing Overview
Routing Options and File Locations
Routing Templates
Routing Best Practices
Toolbars
Connection Points and Route Points
Pipes and Tubes
General Procedure for Pipes and Tubes
Components
Working with Routing Assemblies
Drawings of Routing Assemblies
Drawings of Routing Assemblies
Bill of Materials for Routing Assemblies
Piping Drawings
Pipe Drawing PropertyManager
Including a Bill of Materials in a Piping Drawing
Creating a Drawing of a Piping Assembly
Electrical Cables
Coverings
Sheet Metal
Simulation
SimulationXpress
Sketching
Sustainability Products
SolidWorks Utilities
Tolerancing
Toolbox
Weldments
Workgroup PDM
Troubleshooting
Glossary
Routing > Pipes and Tubes > Drawings of Routing Assemblies > Including a Bill of Materials in a Piping Drawing
Hide Table of Contents Show Table of Contents

Including a Bill of Materials in a Piping Drawing

You can include the billi of materials with a piping drawing when you create the drawing.
Before you create the drawing, click Options (Standard Toolbar) and click File Locations to select default paths for sheet formats and bills of materials.
  1. From a saved routing assembly, click Pipe Drawing .
  2. Click to select a sheet format template.

  3. Select Piping BOM template and click to select a BOM template.

  4. Select other options and click .



Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Including a Bill of Materials in a Piping Drawing
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2010 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2010 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.