> Setting Multiple Jogs in Dimension Leaders
Introduction
What's New
Administration
User Interface
SolidWorks Fundamentals
Moving from 2D to 3D
Assemblies
CircuitWorks
Configurations
Design Checker
Design Studies in SolidWorks
Detailing and Drawings
DFMXpress
DriveWorksXpress
FloXpress
Import/Export
Mold Design
Motion Studies
Parts and Features
PhotoView 360
PhotoWorks
Routing
Sheet Metal
Simulation
SimulationXpress
Sketching
Sustainability Products
SolidWorks Utilities
Tolerancing
Toolbox
Weldments
Workgroup PDM
Troubleshooting
Glossary
Hide Table of Contents Show Table of Contents

Setting Multiple Jogs in Dimension Leaders

You can apply multiple jogs to existing dimension and callout leaders by clicking Multi-jog Leader from the Leaders tab of the Dimension PropertyManager. You can also add jogs after you place a dimension or callout by right-clicking and selecting Add Jog Point. Drag jog points to create the jog after inserting the jog point.

To include multiple jogs in leaders when creating radius, diameter, chamfer, or hole callout dimensions:

  1. Select Smart Dimension .
  2. In the graphics area, right-click and click Use Multi-jog Leader.
  3. Select the entity to dimension.
  4. Click to place leader jogs, and double-click to place the dimension.

    You can drag dimension jogs after setting them.



Related SolidWorks Forum Content

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting Multiple Jogs in Dimension Leaders
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2010 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.