> Parts and Features > Features > Extrudes > Extrude Feature Overview
Hide Table of Contents Show Table of Contents

Extrude Features

The Extrude PropertyManager defines the characteristics of extruded features. You can create these types of extruded features:

Type of Extrude

 

  • Solid or thin

  • Boss/base

  • Cut

  • Surface

  • You can also use Instant3D and RapidSketch to create extrudes.

  • When you create an extrude of a slot sketch, you can view the slot's central temporary axis. This capability is particularly useful for mating fasteners at the center of slots in assemblies.

 

You can also use Instant3D and RapidSketch to create extrudes.

 To create an extrude feature:

  1. Create a sketch.

  2. Click one of the extrude tools:

    • Extruded Boss/Base on the Features toolbar, or click Insert, Boss/Base, Extrude

    • Extruded Cut on the Features toolbar, or click Insert, Cut, Extrude

    • Extruded Surface on the Surfaces toolbar, or click Insert, Surface, Extrude

  1. Set the PropertyManager options.

To extrude in both directions from the sketch plane, set the PropertyManager options in Direction 1 and Direction 2. To extrude as a thin feature, set the PropertyManager options in Thin Feature. When you drag the manipulator to set the size, an Instant3D ruler appears so you can set precise values.

  1. Click .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Extrude Features
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2010 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.