Hide Table of Contents

Select Loop

You can select a loop of connecting edges on a part. Hidden edges are selected in all view modes.

To select connecting entities in a sketch, use Select Chain.

To select a loop:

  1. On a part, right-click an edge and choose Select Loop.

A loop is selected on one face. A handle displays the direction of the loop.

  1. To change the loop selection to the edges of the other connecting face, click the handle.

 

When you select a face, all loops on the face are selected. You can choose one of the loops.

To select a loop on a face:

  1. Select a face.

  1. Hold Ctrl and select an edge of a loop.

The complete loop is selected.

Only the selected edge is highlighted.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Select Loop
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.