Hide Table of Contents

Circle PropertyManager

Controls the properties of a perimeter-based or center-based sketched Circle.

Existing Relations

  • Relations . Displays relations inferenced automatically during sketching or created manually with Add Relations. When you select a relation in the list, a callout is highlighted in the graphics area.

  • Information . Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on).

Add Relations

    You can add relations to the selected entity. The list includes only relations that are possible for the selected entity.

Options

For construction. Converts the entity to construction geometry.

Parameters

You can specify any appropriate combination of the following parameters to define the circle if the circle is not constrained by relations.

    With Center creation selected, set values for:

    Center X Coordinate

    Center Y Coordinate

    Radius

Related Topics

3D Circle PropertyManager

Dimensions Between Arcs or Circles

Ellipse PropertyManager

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Circle PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.