Rectangles
Sketch the following rectangles:
Rectangle types |
Tool |
Rectangle
properties |
Corner Rectangle |
|
Sketches standard rectangles. |
Center Rectangle |
|
Sketches rectangles at a center point. |
3 Point Corner Rectangle |
|
Sketches rectangles at a selected angle. |
3 Point Center Rectangle |
|
Sketches rectangles with a center point at a selected angle. |
Parallelogram |
|
Sketches a standard parallelogram. |
The
SolidWorks application defaults to the last used rectangle type. You can
also use the rectangle tools (Sketch toolbar).
Rectangle Sketch Commands
Access the rectangle tools by:
Sketch
tab. Clicking the Rectangle Command
Manager, to select rectangle tools from the Rectangle
flyout
tool.
Menu. Clicking Tools,
Sketch Entities to select rectangle
tools.
Rectangle
PropertyManager. Changing to different rectangle tools from the Rectangle
PropertyManager.
To sketch
corner rectangles:
Click Rectangle
.
Click to place the first corner of the rectangle,
drag, and release when the rectangle is the correct size and shape.
Click .
To sketch
center rectangles:
Click Center
Rectangle .
In the graphics area:
Click to define the center.
Drag to sketch the rectangle with centerlines.
Release to set the four edges.
Click .
To sketch 3
point corner rectangles:
Click 3 Point
Corner Rectangle .
In the graphics area:
Click to define the first corner.
Drag, rotate, and then release to set the
length and angle of the first edge.
Click and drag to sketch the other three edges.
Release to set the four edges.
Click .
To sketch 3 point
center rectangles:
Click 3 Point
Center Rectangle .
In the graphics area:
Click to define the first corner.
Drag and rotate to set one half the length
of the centerlines.
Click and drag to sketch the other three edges
and centerlines.
Release to set the four edges.
To sketch
parallelograms:
Click Parallelogram
.
In the graphics area:
Click to define the first corner.
Drag, rotate, and then release to set the
length and angle of the first edge.
Click, rotate, and drag to set the angle and
length of the other three edges.
Release to set the four edges.
To change the size or shape of a rectangle:
In an open sketch, drag a side or
vertex.
Click Tools, Sketch Settings, Detach Segment on Drag to force
sketch segments to detach when you drag them for all rectangle types except
Center Rectangle and 3 Point Center Rectangle
.
To change the properties of an individual
line in the rectangle: