Hide Table of Contents

Mesh Control Parameters

Mesh control refers to specifying different element sizes at different regions in the model. A smaller element size in a region improves the accuracy of results in that region. You can specify mesh control at vertices, points, edges, faces, and components. Mesh control is not available for beams.

To access the Mesh Control PropertyManager, right-click the Mesh icon and select Apply Mesh Control.

Mesh Control Parameters

The mesh control parameters are:

  • Element size (e) for the specified entities

  • Element growth ratio (r)

Assuming that the element size used for meshing an entity is (e), the average element size in layers radiating from the entity will be: e, e*r, e*r2, e*r3, ...., e*rn. If the calculated average element size of a layer exceeds (E), where (E) is the Global Size, the program uses (E) instead. The mesh radiates from vertices to edges, from edges to faces, from faces to components, and from a component to connected components.

To apply mesh control to mixed types of entities:

  1. In the Simulation study tree, right-click the Mesh icon and select Apply Mesh Control.

The Mesh Control PropertyManager appears.

  1. In the graphics area, select the entities for which you want to apply mesh controls.

  2. Under Control Parameters, do the following:

    1. Select a unit and type a value in the Element Size box .

    2. Type a value in the Ratio box .

  1. Click .

To apply mesh control to multiple components:

  1. In the Simulation study tree, right-click the Mesh icon and select Apply Mesh Control.

The Mesh Control PropertyManager appears.

  1. Click the FeatureManager design tree tab .

  1. In the FeatureManager flyout, select the components to which you want to apply mesh control.

The selected components appear in the Selected Entities list box.

  1. Under Selected Entities, select Use per part size.

The software assigns an optimum element size for mesh control to individual components based on their volume. Move the Mesh Density slider towards Coarse to increase the element size by a factor of 2, or towards Fine to decrease the element size by a factor of 0.5.

  1. Click .

Related Topics

Component Mesh Control

Examples of Mesh Control



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Mesh Control Parameters
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.