Hide Table of Contents

End Condition Types

The Type determines how far the feature extends.

Blind

Extends the feature from the sketch plane for a specified distance.

 

 

Through All

Extends the feature from the sketch plane through all existing geometry.

 

 

Up to Next

Extends the feature from the sketch plane to the next surface that intercepts the entire profile. (The intercepting surface must be on the same part.)

 

 

Up to Vertex

 

Extends the feature from the sketch plane to a plane that is parallel to the sketch plane and passing through the specified vertex.

Select a vertex.

 

 

Up to Surface

Extends the feature from the sketch plane to the selected surface.

Select a face to specify the surface.

 

 

Offset from Surface

Extends the feature from the sketch plane to a specified distance from the selected surface.

Select a face to specify the surface, then specify an offset distance.

 

 

Up to Body

Extends the feature up to the selected body. Use this option with assemblies, mold parts, or multibody parts.

Select a solid or surface body up to which the feature extends.

 

 

Mid Plane

Extends the feature from the sketch plane equally in both directions.

Specify a depth.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   End Condition Types
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.