Hide Table of Contents

Unigraphics Files

The Unigraphics translator imports the Parasolid information of a Unigraphics® part or assembly into a SolidWorks part or assembly document. Only the Parasolid information is extracted, not the proprietary feature information of a Unigraphics part.

You can import Unigraphics compressed part files.

To open a Unigraphics part or assembly:

  1. Click Open (Standard toolbar) or File, Open.

  2. In the dialog box, set Files of type to Unigraphics (*.prt), then click Options.

  3. In the Import Options dialog box, under General, select or clear:

  • Import multiple bodies as parts. Imports a multibody part as separate part documents in an assembly document.

  • Under UG, Import tool bodies. Tool bodies are used to construct the final bodies.

  1. Click OK.

  2. Browse to a file, and click Open.

Version Information

You can import parts and assemblies from Unigraphics version 10 and higher, including import of Unigraphics NX 4 files.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Unigraphics Files
*Comment:  

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2011 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.