> Edit Sketch Plane
Hide Table of Contents Show Table of Contents

Edit Sketch Plane

Changes the sketch plane.

To change the plane of a sketch:

  1. Select the sketch in the FeatureManager design tree, and click Edit, Sketch Plane.

    - or -

    Right-click the sketch in the FeatureManager design tree, and select Edit Sketch Plane .

  2. Select a new plane in the FeatureManager design tree or select a new planar face in the model for Sketch Plane/Face .

  3. Click OK .



Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Edit Sketch Plane
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2011 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2011 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.