Adding Edge Flanges
To add an edge flange:
In an open sheet metal part, click Edge
Flange (Sheet Metal toolbar) or Insert,
Sheet Metal, Edge
Flange.
In the graphics area, select one or more the edges
for Edge .
There are specific requirements for adding edge flanges
to curved
edges.
In the Edge-Flange
PropertyManager under Flange Parameters:
Click Edit
Flange Profile to edit the sketch of the profile.
Clear Use
default radius and set a non-default value for
Bend Radius .
Set a value for
Gap distance .
Under Angle:
Set a value for
Flange Angle .
NOTE:
If you select Up to Edge and
Merge under Flange Length to merge
two bodies in a multibody part, a lock is added to the flange
angle. You can unlock the angle to change it.
Select a face , and then select
either Perpendicular to face or Parallel to face to create that relation
between it and the edge flange.
Blind:
Up To Vertex.
Select a vertex in the graphics area for Vertex .
Up to Edge and Merge.
(Only available when you select a single
edge in a multibody sheet metal part.) Merges the edge with a parallel
edge of another body. Select an up to reference edge on the second body.
Under Flange
Position, do the following:
Set the Bend Position to Material
Inside , Material
Outside , Bend Outside
, or Bend from Virtual
Sharp .
To remove extra
material in neighboring bends, select Trim
side bends.
To offset the
flange from the sheet metal body, select Offset.
Then, set the Offset End Condition
and its corresponding parameters.
To use values other
than the default bend
allowance, select Custom Bend
Allowance and set a value for Bend
Allowance Type. For example:
Set Bend Allowance Type to: |
Then: |
|
Click Browse to locate the bend table |
|
Set a value for K-Factor |
Bend
tables are located under: <install_dir>\lang\<language>\Sheetmetal Bend Tables.
To add relief cuts, select ,
then select the type of relief cut:
If Relief
Type is:
Rectangle
or Obround and you select Use relief ratio,
set a value for Ratio.
Rectangle
or Obround and you clear Use relief ratio,
set values for Relief Width and
Relief Depth .
Tear select
Rip or Extend .
Click
OK .