Hide Table of Contents

Hole Sizes in Configurations

In the Hole Specification PropertyManager, you can configure the size of Hole Wizard holes by clicking Configurations and selecting This configuration, All configurations, or Specify Configurations.

 

The column header in a design table to control the hole size uses this syntax:

$HW-SIZE@feature_name

The column header is not case sensitive.

Click in the table body cells and select hole sizes from the lists. If a cell is left blank, the default hole size is the smallest one available for that hole type.

Example of a design table that controls the size of a Hole Wizard hole:

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Hole Sizes in Configurations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26