Hide Table of Contents

Workflow States

A workflow state represents a lifecycle stage for a file or process.

Each state has a name, such as "Initiated", "Waiting for approval", or "Approved". For each state, you can define user and group permissions (rights), such as being able to check out files or increment revision numbers.

Every workflow must have at least one state. One and only one state must be designated the initial state. All new files added to a workflow start in the initial state.

In the workflow editor, a state is shown as a box with the state name, a descriptive icon on the left side, and status icons on the right side.

The status icons indicate:

workflow_UI_initial_state Initial state All new files added to a workflow start in the initial state.

There can only be one initial state in a workflow.

workflow_UI_ignore_permissions Ignore permissions in previous states Access rights applied to this state override any inherited state rights from previous states.

To the end user, the state of a file is displayed in the State column of an Enterprise PDM Explorer View file listing. Also, if data cards are set up, the History dialog box and Version information tab display the file state.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Workflow States
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.