Hide Table of Contents

Solution Time After Impact

This is a real period of time for which the program calculates the response starting from the moment of the first impact. If you specify a drop height, the solution time does not include the period of the free fall of the body. The program estimates a value for the solution time based on the model geometry and default material properties. The default solution time is based on the time it takes the elastic wave generated by the impact to travel through the model. The program estimates the velocity (Ve) of the elastic wave from:

Ve= (EX/r)1/2

Where EX is the modulus of elasticity and r is the density. The wave starts propagating in the model at the moment of impact. Assuming that the length of the model is L, the wave takes a time period approximately equal to 2L/Ve to travel to the farthest boundary, get reflected, and travel back to the originating area. Forces that are opposite to gravity start acting on the model during this period. The program sets the default solution time to 3L/Ve. Note that this is just an estimate that should help you enter a reasonable period.

The impact period is usually very small. This is why the program asks for it in microseconds. The maximum response may occur during impact or after while the body is rebounding. The study can evaluate multiple impacts and rebounds if you specify an adequate solution time.

The program gives a warning message if it estimates that solving the problem will take more the 60 minutes.

Related Topics

Drop Test - Contact

Drop Test - Materials

Drop Test - Result Options

Drop Test - Setup

Drop Test - Studies

Drop Test - Viewing Results

Performing Drop Test Analysis

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Solution After Impact
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.