> Motion Studies > Motion Study Plots > Plot Properties > Number/Scale Properties

Introduction

Administration

User Interface

SolidWorks Fundamentals

Design Studies in SolidWorks

Drawings and Detailing

Introduction to Motion Studies

Accessing and Naming Motion Studies

MotionManager Interface

Motion Elements

Motor and Force Profiles

Displacement, Velocity, and Acceleration Type Plots

Force and Torque Plots

Energy and Momentum Type Plots

Orientation, Reflected Load, and Other Plots

Including Motion Results in Sensors

Results PropertyManager (Motion Analysis only)

Plot Properties

Plot Defaults Dialog Box

Example: 1 Plot vs. 2 Plots

Moving Marker Properties

Number/Scale Properties

Motion Study Mates

Motion Along a Path

Event-based Motion Analysis

Rigid Groups

Stress Analysis for Motion

Motion Study Troubleshooting

Sustainability Products

Number/Scale Properties

Axis

X Axis. Select to apply properties to the x-axis.
Y Axis. Select to apply properties to the y-axis. Enter the specific y-axis in the Y Axis Number box below.
- Y Axis Number. (Only available when Y Axis is selected.) Enter the y-axis whose properties you want to modify. Only used if more than one plot appears on the same chart. For more information see Motion Results PropertyManager.

Auto

Select any of the following to have the value automatically set, or clear to manually set the value.

Start Point. Minimum value for the axis.
End Point. Maximum value for the axis.
Major Units. Spacing between major unit tick marks along the select axis.
Minor Units. Spacing between minor unit tick marks along the select axis.

Number Format

General. Display numbers in general notation along the selected axis.
Scientific. Display numbers in scientific notation along the selected axis.

Decimal Places. Enter the number of decimal places to display for numbers along the selected axis.

Use 1000 Separator. Insert a comma to separate values in four-digit or greater labels.

Search 'Number/Scale Properties' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Number/Scale Properties
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.