> Motion Studies > Motion Study Plots > Orientation, Reflected Load, and Other Plots > Plotting Normalized Rodrigues Parameters
Introduction
Administration
User Interface
SolidWorks Fundamentals
Moving from 2D to 3D
Assemblies
CircuitWorks
Configurations
SolidWorks Costing
Design Checker
Design Studies in SolidWorks
Drawings and Detailing
DFMXpress
DriveWorksXpress
FloXpress
Import and Export
Large Scale Design
Model Display
Mold Design
Motion Studies
Introduction to Motion Studies
Accessing and Naming Motion Studies
MotionManager Interface
Motion Elements
Motor and Force Profiles
General Techniques
Animation
Component Contact
Motion Study Plots
Displacement, Velocity, and Acceleration Type Plots
Force and Torque Plots
Energy and Momentum Type Plots
Orientation, Reflected Load, and Other Plots
Yaw, Pitch, and Roll in Results
Euler Angle Results
Bryant Angle Results
Plotting Rigid Body Orientation
Plotting Normalized Rodrigues Parameters
Plotting Projection Angles for Rotating Parts
Reflected Load Inertia and Reflected Load Mass
Including Motion Results in Sensors
Results PropertyManager (Motion Analysis only)
Plot Properties
Motion Study Mates
Motion Along a Path
Event-based Motion Analysis
Rigid Groups
Stress Analysis for Motion
Motion Study Troubleshooting
Parts and Features
Routing
Sheet Metal
Simulation
SimulationXpress
Sketching
Sustainability Products
SolidWorks Utilities
Tolerancing
Toolbox
Weldments
Workgroup PDM
Troubleshooting
Glossary
Hide Table of Contents Show Table of Contents

Plotting Normalized Rodrigues Parameters

Rodrigues parameters specify the transformation of coordinates between a rotating frame and another reference frame. You can plot normalized Rodrigues parameters to specify the rotational orientation of a moving part.

  1. From a Motion Analysis study, click Results and Plots (MotionManager toolbar).
  2. In the PropertyManager, for Category, select Other Quantities.
  3. For Subcategory select Rodriguez Parameters.
  4. For Select result component, select one of the following:
    • Parameter 1 to calculate the first Rodrigues parameter.
    • Parameter 2 to calculate the second Rodrigues parameter.
    • Parameter 3 to calculate the third Rodrigues parameter.

  5. For features , select a part face to calculate the result for the rotational motion of the part.
  6. Select the Plot Results options you require, and click .

    The result appears in the MotionManager tree.

  7. Click Calculate (MotionManager toolbar).


Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Plotting Normalized Rodrigues Parameters
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2012 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2012 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.