Hide Table of Contents

Edge Selection Tools

To automatically select a different chain of edges:

  1. Right-click and select Clear Selections.

  2. Select an edge.

  3. Click Propagate to list all the edges in the loop.

To manually select each edge:

  1. Right-click and select Clear Selections.

  2. Select an edge.

    In the graphics area a red arrow appears at the endpoint of the edge and indicates a possible next edge, and selection tools appear in the PropertyManager.

  3. In the PropertyManager, click the selection tools as needed until the chain of edges is complete:

    • Add selected edge . Adds the edge indicated by the red arrow to Edges.

You can press Y instead of Add selected edge .

  • Select next edge . Changes the red arrow to indicate a different possible next edge.

You can press N instead of Select next edge .

  • Zoom to the selected edge . Zooms to the edge selection area.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Edge Selection Tools
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.