Hide Table of Contents

Editing Imported Features

You can replace an imported feature with geometry from a new file.

To edit a feature created from an imported document:

  1. In the FeatureManager design tree, right-click the feature created from the imported document, and select Edit Feature.

     The Open dialog box appears.

  2. In the Files of type list, select the desired format.

  1. Browse to select the desired file to import.

    The file name appears in the File name box.

  2. Select the Match faces and edges check box, if desired. This does the following:

  • Propagates the dependencies of the old faces and edges in the old body, such as sketches or features, to the new faces and edges in the new body.

  • Ensures you get the correct results when you open a file that has imported features.

  1. Click Open.

    An imported solid is replaced only if the data in the new document can be successfully knitted into a body. A surface feature is replaced with the first surface in the new document, and subsequent surfaces in the new file are added to the model.

  You can edit only features that were created from an ACIS, Autodesk Inventor, IGES, Parasolid, Pro/ENGINEER, Solid Edge, STEP, VDAFS, or VRML file.

If you had added features to the imported body before selecting Edit Feature, SolidWorks attempts to rebuild these features whenever possible.

For example, this STEP file contains an imported feature. You need to add a feature to the imported body.

  1. Select the bottom face of the imported body.

  2. Click Chamfer .

    The Chamfer PropertyManager appears.

  1. Under Chamfer Parameters, make the desired settings and click OK .

    The imported body now shows the additional chamfer feature on the bottom face.

  1. Right-click Imported1 in the FeatureManager design tree and select Edit Feature.

    A message box appears warning that this feature has a parent/child relation or is being referenced.

  2. Click OK.

    The Open dialog box appears.

  3. Select the STEP file and click Open.

    The STEP file opens with the imported body. The chamfer feature that you added to the imported body is rebuilt. You did not have to rebuild this feature that you had added to the imported body before selecting Edit Feature.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Editing Imported Features
*Comment:  

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2012 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.