Hide Table of Contents

Appearances Surface Finish PropertyManager

The Appearance Surface Finish PropertyManager sets the type of surface on the appearance, for example, knurled, dimpled, or sandblasted.

To display this PropertyManager, in the DisplayManager, click View Appearances . Right-click an appearance and select Appearance. In the PropertyManager, click Advanced and click the Surface Finish tab.

Surface Finish

  Type of finish Depending on the type you select, additional options appear.
  Dynamic help Displays pop-up tooltips for each property.
  From File options
Image path
Uses data in the file you specify to create the surface finish.
Browse
Click to locate and select an image file representing the surface finish.
Normal Map
Indicates a normal map image, appropriate for bump mapping and RealView. Clear this check box to indicate a height map image, appropriate for displacement mapping. If you use a normal map image for displacement mapping, you may experience undesirable surface distortions.
  Knurled options
Knurl angle
Changes the angle between knurls. Units are in degrees.
Knurl height cap
Sets the height of the plane at the top of the knurl as a percentage of the height of the surface finish. Set to 0 to assign no height to the knurl, effectively hiding it. Set to 1 to create knurls at full height. Set to .5 to leave knurls at half height, with flat tops.
  Dimpled option
Dimple size
Sets the diameter of the dimple.

PhotoView Surface Finish

The following options are available when PhotoView is added in.

  Bump Mapping Simulates an uneven surface by modifying shadows and reflections without changing the geometry. Renders more quickly than Displacement Mapping.
  Bump strength Sets the bump height to the distance from the highest point of the bump surface to the model surface.
  Displacement Mapping Adds texture to the rendered model surface, changing the geometry. Renders more slowly than Bump Mapping.
  Displacement distance Controls the distance from the nominal surface to the displacement mapped surface finish.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Appearances Surface Finish PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.