> SolidWorks Utilities > Find/Modify Utility > Find/Modify Overview
Introduction
Administration
User Interface
SolidWorks Fundamentals
Moving from 2D to 3D
Assemblies
CircuitWorks
Configurations
SolidWorks Costing
Design Checker
Design Studies in SolidWorks
Drawings and Detailing
DFMXpress
DriveWorksXpress
FloXpress
Import and Export
Large Scale Design
Model Display
Mold Design
Motion Studies
Parts and Features
Routing
Sheet Metal
Simulation
SimulationXpress
Sketching
Sustainability Products
SolidWorks Utilities
SolidWorks Utilities
Compare Utility
Feature Paint
Find/Modify Utility
Find/Modify Overview
Find/Modify/Supress Feature Selection
Finding Matched Feature Parameters
Modifying Feature Parameters
Known Limitations of Find/Modify
Find Replace Annotations
Geometry Analysis
Power Select
Report Manager
Simplify Utility
Symmetry Check Utility
Feature Parameter vs. Volume-based Feature Simplification
Thickness Analysis Overview
Tolerancing
Toolbox
Weldments
Workgroup PDM
Troubleshooting
Glossary
Hide Table of Contents Show Table of Contents

Find/Modify Overview

The Find/Modify utility lets you find a set of features in a part that satisfy specified parameter conditions, then edit them in a batch mode.

Find/Modify lets you:

  • Find features that belong to a specific type.

  • Find features of a specific type and satisfy specified parameter conditions. For example, you can find all simple holes less than 10mm in diameter.

  • Modify selected features from the list of found features. For example, you can change all holes less than 10mm in diameter to 5mm diameter holes.



Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Find/Modify Overview
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2012 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2012 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.