Hide Table of Contents

Filtering Components by Size

Toolbox administrators can filter selected Toolbox components and component sizes from Toolbox Settings.

  1. From Windows, click Start > All Programs > SolidWorks version > SolidWorks Tools > Toolbox Settings .
  2. Click 2 - Customize Your Hardware.
  3. From the Customize Hardware page, clear selections to exclude any unnecessary standards, component categories, and component types.

  4. Click a standard, component category folder, and a component type in the category.

    The selected component type appears at the top of the Customize Hardware page.

  5. From Standard Properties, click Size, and clear any unnecessary sizes.

    You can also change other standard properties for selected components at this point.

  6. Repeat steps 3 and 4 for other components you do not require.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Filtering Components by Size
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.