Hide Table of Contents

Ordering Balloons

In addition to creating balloons, stacked balloons, and auto balloons following the assembly order, you can create balloons and number them sequentially. For balloons, auto balloons, or stacked balloons, you can also control the direction of the ordering (for example, left to right or right to left for a linear arrangement), as well as which balloon is designated as the first balloon.

To order balloons sequentially:
  • A bill of materials must exist in the drawing. Ordering balloons sequentially reorders the bill of materials.
  • You must link the balloons to the bill of materials. When you create a new bill of materials, the balloons are automatically linked to it. In cases where they are not linked, you can link them by right-clicking in the drawing view and clicking Properties. In the Drawing View Properties dialog box, on the View Properties tab, under Balloons, select Link balloon text to specified table, and click OK.
  • You must add the balloons to the drawing. Existing balloons cannot be reordered.
In this example, you:
  • Insert a bill of materials.
  • Use Auto Balloons to insert balloons following the assembly order.
  • Reorder the balloons sequentially.
  • Designate a balloon as the first balloon.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Ordering Balloons
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.