Hide Table of Contents

Fitting to Displays

To fit a document window to the display:

  • Click Fit to Left Display Fit to Left Button, Fit to Right Display Fit to Right Button, Fit to Top Display Fit to Top Button, or Fit to Bottom Display Fit to Bottom Button on the right side of the document window's title bar.

    Fit to Display Button Location

    If two displays are configured side-by-side, or if only one display is connected, the available buttons are Fit to Left Display and Fit to Right Display. If two displays are configured one above the other, the available buttons are Fit to Top Display and Fit to Bottom Display.

    Display Configuration Result
    Two or more displays available, and the SolidWorks window spans two displays. The document window fits to the appropriate display.
    Two or more displays available, and the SolidWorks window does not span two displays. The SolidWorks window resizes to span two displays and the document window fits to the appropriate display.
    One display available The document window fits to the appropriate half of the display.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Fitting to Displays
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.