Highlights of SolidWorks 2012
Legal Notices
User Interface
SolidWorks Fundamentals
Installation
Assemblies
Large Design Review
Assembly and Component Information
Reviewing Assemblies
Measurements
Section Views
Isolate
Walk-throughs
Snapshots
Save
Component Changes
Opening and Resolving Components
Usability and Workflow Improvements
CircuitWorks
Configurations
Costing
Drawings and Detailing
eDrawings
SolidWorks Enterprise PDM
Flow Simulation
Import/Export
Motion Studies
Parts and Features
Routing
Sheet Metal
Simulation
Sketching
Sustainability
Toolbox
Weldments
SolidWorks Workgroup PDM
Hide Table of Contents Show Table of Contents

Measurements

You can measure the distance between entities in Large Design Review.

Click Measure Tool_Measure_Tools.gif or Tools > Measure. When you select two entities (vertices, edges, or faces) the software reports the approximate distance between them.
Limitation
Measurement accuracy depends on image quality. To obtain accurate measurements, you must fully resolve the model.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Measurements
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: What's New 2012 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document What's New 2012 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.