> Drawings and Detailing > Drawings > Getting Started in Drawings > Inserting Images in Drawings
Hide Table of Contents Show Table of Contents

Sketch Picture in Drawings

You can insert pictures (files of type .bmp, .gif, .jpg, .jpeg, .tif, and .wmf) into a drawing as in a sketch.

To insert a picture into a drawing:

  1. Click Sketch Picture (Sketch toolbar) or Insert, Picture.

  2. In the Open dialog box, browse to an image file, then click Open.

  3. Select options in the Sketch Picture PropertyManager, then click .

Images are inserted with their (0,0) coordinates at the (0,0) position in the drawing (lower left corner).

  • You can drag and resize images in the graphics area.

  • You can control position, size, rotation, and transparency of images in the Sketch Picture PropertyManager.

  • To open the PropertyManager and enable dragging, double-click the image.

Related Topics

Sketch Picture



Related SolidWorks Forum Content

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Picture in Drawings
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2012 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.