Hide Table of Contents

Repair Route

You can correct violations of the minimum bend radius requirements of a cable or flexible tube.

To repair violations of the minimum bend radius requirements:

  1. Click Repair Route (Routing Tools toolbar) or Routing, Routing Tools, Repair Route.

  2. In the graphics area, select a spline that violates minimum bend radius requirements.

  3. To preview different solutions, do one of the following:

    • Right-click in the graphics area.

    • Click and in the PropertyManager.

  4. To accept a solution, click in the graphics area or click in the PropertyManager.

You can also repair violations of the minimum bend radius requirements while in the Edit Wires PropertyManager by right-clicking an item under Wire From-To List and selecting Repair route.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Repair Route PropertyManager
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.