Hide Table of Contents

Components with Multiple CPoints

Certain types of fittings, for example tees and crosses, can have multiple connection points (CPoints), but not all points need to be included in a route.

When you drag a routing component with multiple CPoints to create a route, you can select the points to include in the route from the Multiple CPoints dialog box, provided the component is set up for multiple connection point selection.

You can also right-click a connection point in the graphics area to add or remove it from a route.

You can set up connection point handling for a component with multiple CPoints in the Routing Component Wizard.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Components with Multiple CPoints
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.