Hide Table of Contents

Routing Component Wizard

Use the Routing Component Wizard to prepare and validate the component.

To use the Routing Component Wizard, open the component file and then access the Routing Component Wizard from Routing tools. Step through the pages, selecting any options you need. If the component does not have a connection point, you can use the wizard to add it.

At the end of the wizard, save the component and add it to the Component library.

The wizard also allows you to define the drag and drop behavior for adding connection to the route. You can set it to add all connection points, add none, or specify which points to add.
If you are using a From-To List, this setting is ignored. The connection points that are referenced in the From-To List are for multiple connection points components.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Routing Component Wizard
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.