Hide Table of Contents

Changing Properties for Subsequent Route Segments

You change the route properties for all subsequent route segments in the Route Properties PropertyManager.

While creating a route, or starting a new route, you can change route properties to apply to all segments created after you insert the next fitting. This does not change the properties of segments created up to that point.

To change the route properties for all subsequent route segments:

  1. Do one of the following:
    • Click Route Properties .
    • Right-click a route feature in the FeatureManager design tree and select Route Properties.
  2. Set options in the Route Properties PropertyManager.
  3. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing Properties for Subsequent Route Segments
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.