Hide Table of Contents

Changing the Editing Focus Manually

For some types of editing operations, you need to specify that the changes you are making belong to the sub-assembly, and not to the top-level assembly. This includes any case where the edits could be successfully applied to either one. For example, you can add an assembly feature hole either to a sub-assembly, or to the top-level assembly, with different results.

You must activate the sub-assembly to perform these editing operations:

  • Add a component into the sub-assembly. You cannot add a new component in the context of a sub-assembly.

  • Delete a component from a sub-assembly.

  • Add a component pattern, an assembly feature cut or hole, a sketch, or reference geometry to the sub-assembly.

  • Use dynamic assembly motion on sub-assembly components. You can fix, float, and move sub-assembly components when the sub-assembly is active, to visualize the movement within the sub-assembly.

  • Add a mate between components of the active sub-assembly (both at the same level in the hierarchy, or one at a lower level, in a nested sub-assembly of the active sub-assembly).

NOTE: While a sub-assembly is active, the mates in the top-level assembly that position the sub-assembly with respect to the top-level are temporarily ignored. Top-level mates are solved again when you return to editing the top-level assembly and click Rebuild .

You cannot add a mate between a component within an active sub-assembly and a component outside the active sub-assembly.

To activate a sub-assembly for editing in context:

Select the sub-assembly and click Edit Component on the Assembly toolbar, or right-click the sub-assembly icon in the FeatureManager design tree, and select Edit Sub-assembly.

When you activate a sub-assembly, it turns blue, and the rest of the assembly turns gray, just as it does when you edit a part. When you edit a component of a sub-assembly, only the individual part being edited turns blue. See Colors When Editing a Component.

To return the editing focus to the top-level assembly:

Click Edit Component again, or right-click and select Edit Assembly.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing the Editing Focus Manually
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.